Mecha Proof W-2K phụ gia ức chế rỉ sét cho gia công phóng điện dây

Inhibit rust by diluting and adding to wire EDM processing fluid.

Uses: Rust prevention for wire electric discharge machining

How to use

First dilute -> then add to processing fluid

Dilute

• ① Collect 10 to 20 liters of processing fluid in a bucket/container.
• ② Add the following amount of W-2K to the collected fluid ① and mix.
  Immersion-type machine: about 0.2 to 0.5% of the machine’s total tank fluid
  Flushing-type machine: about 0.5 to 0.6% of the machine’s total tank fluid

Add to processing fluid

• ③ Pour the diluted fluid ② into the tank.
• ④ Circulate for about 20 minutes to make the concentration uniform.

Note: When rust prevention effectiveness later decreases (timing varies depending on usage conditions), add 5 to 10% of the amount of W-2K added in step ② to the tank.

Caution

• If the processing fluid becomes extremely dirty due to sludge, etc. after long-term use, it should be fully replaced.
• Splashed fluid may leave white crystals when it evaporates, but this is natural. Simply pour hot or cold water on the crystals to dissolve them.
• Always read the Safety Data Sheet (SDS) before use.
• Please contact us to request the Safety Data Sheet (SDS).